Super Detailed Steps to Replace Refrigerator Door Seal

Replacing a refrigerator door seal is a relatively simple process, but requires some attention to detail. The following are the detailed replacement steps:

1. Prepare tools and materials

Tools: screwdriver (may be used to fix the screws of the door seal), flat-nosed pliers or knives (used to remove the old door seal), rubber mallet or similar tools (used to install the new door seal when tapping to make it fit), ruler (used to measure the length of the new door seal), insulating tape or screws (used to fix the new door seal, depending on the specific circumstances).

Material: new refrigerated cabinet door seal, make sure to match the model and size of the old door seal.

2. Remove the old door seal

Open the refrigerator door: make sure that the refrigerator door is fully open and that there is enough space to operate.

Remove gently: Use flat-nosed pliers or your hands to start from one end of the door seal and gently remove it from the door frame. If the door seal is badly aged, it may crumble or be difficult to remove. At this point, you can use a knife to carefully cut it off and then remove it section by section.

3. Cleaning the door frame

Clean the door frame: use detergent or soapy water to thoroughly clean the dirt and residue on the door frame to ensure that the door frame is clean and free of grease.

Dry the door frame: Dry the door frame with a dry cloth to ensure that there is no moisture residue.

4. Measure and prepare the new door seal

Measure the length: Use a ruler to measure the length of the old door seal and make sure the length of the new door seal matches it.

Prepare the new door seal: If the new door seal is too long, use a knife to cut it to the right length. If the door seal has curved or uneven parts, you can gently adjust it to be straight by hand or tool.

5. Installing the new door seal

Insert the door seal: Insert the new door seal into the groove of the door frame starting from one side of the frame. Pay attention to insert from top to bottom, make sure the door seal is flush at the top and bottom, there can’t be any bend or warped place.

Fixing the door seal: If the new door seal needs to be fixed, you can use insulating tape or screws to fix it to the door frame. When fixing, be careful not to use too much force to avoid damaging the door seal or door frame.

Tap to fit: Use a rubber mallet or similar tool to gently tap the door seal to make it fit tightly on the door frame. Be careful to knock evenly to ensure that there is no gap between the door seal and the door frame.

6. Check the sealing

Close the refrigerator door: close the refrigerator door, check whether the door seal and the door frame close fit.

Test the sealing: you can use your hand to gently press the door seal, check whether there is air leakage phenomenon. You can also put a piece of paper between the door frame and the door seal, then close the refrigerator door and pull out the paper, if the paper can be easily pulled out, it means that the sealing is not good, you need to readjust the door seal.

Precautions

When replacing the door seal, make sure the refrigerator has been disconnected and stopped to avoid accidents.

When replacing the door seal, choose a new door seal that matches the model and size of the original door seal to ensure sealing.

When installing the new door seal, be careful not to use too much force to avoid damage to the door seal or door frame.

After the installation is completed, the sealing of the door seal should be carefully checked to ensure that the refrigerator can operate normally and achieve the desired preservation effect.

Keywords：

GNR1314L2G fridge installation process,Best GNR1314L2G fridge price